Fret Saws: The Ultimate Luthier's Guide & Recommendations

The laser-cut Acrylic depth stop should be adjusted to cut a slot that is just slightly deeper than the tang of the frets Fret slots which are too deep weaken

Fret Saws: The Ultimate Luthier's Guide & Recommendations I tried wide Then program a 3D finish path cutting the same direction as the fret slot I had to play around with the stepover to get a

The laser-cut Acrylic depth stop should be adjusted to cut a slot that is just slightly deeper than the tang of the frets Fret slots which are too deep weaken

beowulf slot I tried wide Then program a 3D finish path cutting the same direction as the fret slot I had to play around with the stepover to get a

Fret slots should be clean and deep enough to receive the tang with room to spare On bound necks, make sure you get the binding glue out of the corners You'll

fret slot depth When I cut my fret slots I have a piece of fret wire with tangs filed off that I run through the fret to check that the slot is deep enough The

When it comes to CAM I use the 2D trace and pick my fret slotting bit as the tool, and the lines to trace Then use a negative depth to get the