Solidworks Drawing Slot Center Mark by gulfcodes

website slot dimension callout ○ Dimension values in drawing refer to the full size of the object 6 Dimensioning slots Page 30 Ahmed Kovacevic, City University London Design slot 3 cat 2022 Ok, there are three ways according to ASME standard to call out a slot hole One of the ways is individual dimensioned length, widith and with a

slot dimension callout Dimensioning, Continued Slotted holes Dimension slotted holes by width, length, or center points Indicate the end radii but do not dimension them Figure 3  Slot Tool and applying the Maximum and Minimum Conditions to an Arc Dimension  The callout displays all slot-related dimensions that are marked for drawing, plus the THRU-ALL note or depth symbol value if the slot is through or blind

Share

Share

Link

Turn off sharing Copy link

See all details